Modeling project

C887 HMAS Kodiak

In early 2006, the fine personnel of A battery, 1 RCHA went into action with their trusty M777 during the battle of Panjwaii. Firing a surprisingly shot burst, two guns managed to exact substantial casualties to the retreating Talibans. Three weeks later, during a post-action briefing held at NDHQ Ottawa, a civilian analyst, marveling at this particularly shining result obtained with conventional arty, casually wondered if it wouldn’t be worth looking into providing the gunners with a little more operational mobility so that they could throw punches like that further away. The notion was promptly dismissed as “another civilian-who-never-ever-got-shot-at nonsense”.

A few minutes later during the same meeting, the officer in charge was struck by an epiphany. What if we could provide our guys with more mobility to support liaison convoys, security patrols? We could likely mount longer-range offensive without relying on those lousy A-10s that kept firing on our guys. That would be brilliant. Thus was launched what was to become a sluggishly long procurement program. Yet it was off to a good start, for it took only a year to get the necessary approval to proceed with cost and capabilities requirements analysis, and another year to greenlight a procurement commission to shop around.

In typical Canadian fashion. the privileged approach was to try and buy an off-the-shelf platform. A stealthy lobbyist managed to slip a spec sheet of the South African G6 wheeled artillery vehicle to people that mattered and a few months later, an evaluation mission was – quite surprisingly – sent to Thaba Tshwane in Pretoria, then off to Johannesburg to witness a live demonstration from the Transvaal Horse Artillery (now known as the Sandfontein Artillery Regiment). That demonstration went well apparently, with the South African gunners of 8 battery hitting targets more than 40 kilometers away with great accuracy and after successively moving from five different firing positions.

A mere five weeks later, 16 guns were ordered, but for a variety of reasons, these guns weren’t delivered until 2020, a whopping twelve years later, long after they could be of use in Canada’s longest deployment. The system went through a number of modifications and is now operational in the Canadian Forces under the name of Kodiak (the official designation being the C887, High Mobility Artillery System (or “H-Mass” among gunners), but most army personnel now refers to the system as simply the Kodiak (not to be mistaken with the Leopard 2-based gen3 AEV).

Externally, the most immediate difference with the original G6 is the M284 gun in lieu of the quite excellent G5 (itself based on a Canadian gun, the GC-45). This is considered by most analysis to be a step back in pure ballistic envelope. Canada chose this barrel for interoperability reasons with the US Army, and the change is the main culprit for the system taking so long to reach operational status.

Other differences include:

  • Different light clusters on the vehicle’s front, along with an anti-slip pathway and grab handle on the glacis left, as well as a hand guard added on the upper left of the driver’s compartment.
  • A FLW 200 remote weapon station on the turret top, very slightly offset to the right. This made it possible to drop the bulky turret smoke dischargers. The station is not entirely satisfactory due to the limitations on the field of fired on the forward arc. It is unclear whether this arrangement will be kept as formal dotation.
  • Enormous all-terrain, non-directional tread 630/75R34 Michelin battle tires produced under licence by Boisso. Canada retained the original tires for arid deployment (God forbid!) but it was deemed necessary to get more polyvalent shoes for temperate climate.
  • A different, wider design for the turret front steps for better access in winter gear.
  • Complete redesign of the anti-slip patterns on the hull and the turret.
  • A ramp on the turret’s rear right accessway. Contrary to UAE’s massive rail that goes all the way to the turret’s wall, this one is much smaller and only offers an alternate holding point.
  • The antenna point has been moved back the upper rear of the turret. (An anchor point for a T-antenna mount remains available slightly behind the station’s base when the RWS is not mounted.)
  • The absence of any tie-down on the turret sides.
  • The addition of a rear-looking camera.

All in all, the Kodiak is said to be on par with the M109A7 in firepower and protection, with which it shares many FCS and operation management features. It is slightly behind in pure off-road capabilities, but has a much greater operational mobility.

In 2020, four vehicles went from Gagetown to Valcartier using almost exclusively New-Brunswick and Québec country roads, a telling testimony of the system’s robust mobility.

Project Specs

  • Takom G6 Rhino (2052). A great kit. Its only main drawback is the fiddly front wheel assembly that requires somewhat of a long range leap of faith.
  • Live Resin FLW 200 Low Profile (LRE-35240). Wasn’t impressed with this one.
  • 3D Printed Custom Made Wheels. My eternal gratitude goes to Étienne Boisseau for sculpting these sweet sweet piece of modeling.
  • Other 3D printed parts include: rear camera, lights on the front, a small cap over the original antenna location and the steps in front of the turret and a repair part for the FLW 200.
  • Custom made maple leaf and callsign templates, and a few decals from the Trumpeter’s AVGP Grizzly and Echelon’s Canadian Leopard 2A6M sheets.
  • Various custom bits here and there.

Started: Sometimes in the first half of 2020.
Finished: December 2020.

Standard

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s